1mm x 8mm x 4mm x 50mm AlTiSin Coated Carbide 4 Flute Square End Mill 2pcs 5/8"x47mmx14mm Designed for RCA port on

Designed for RCA port on RCA equipment

the inner flow channel is extruded into an M-shaped flow channel

is in size of : 25mm(1 inch) inner dia

select the glass door clip with the corresponding range

1mm x 8mm x 4mm x 50mm AlTiSin Coated Carbide 4 Flute Square End Mill 2pcs 5/8"x47mmx14mm Designed for RCA port onMade of super fine grain carbide, the end mill cutter has high hardness (HRC92), high strength, and wear resistance. With good milling and cutting performance, carbide can run at higher speed than high speed steel. Features square end cut, 4 flute design, large and spiral chip space design for fast and clean chip removal. Sharp cutting edge provides smooth cutting. The AlTiSin composite coating has high hardness, high wear resistance and high thermal