Johnny Joint Rod End 2 Inch Machined Press-In 2 Inch X .500 Inch Ball Internally Greased Incl. Greasable Bolt Fits JL/JT Front End Housing (All Factory Axle Housings) RockJock 4X4 Cyclone V2 5 inch hitch receiver recovery

5 inch hitch receiver recovery point

use warm water with dish soap to clean off any dirt spots

A pair of drive side and passenger side templates with both 97-02 and 03+ bolt hole locations

-Bracket mounts into factory headlight location

Johnny Joint Rod End 2 Inch Machined Press-In 2 Inch X .500 Inch Ball Internally Greased Incl. Greasable Bolt Fits JL/JT Front End Housing (All Factory Axle Housings) RockJock 4X4 Cyclone V2 5 inch hitch receiver recoveryRockJock's Front Axle Housing Johnny Joint, single joint) for JL Wrangler, JL Unlimited and JT Gladiator vehicles replaces either front differential housing upper control arm bushing with a Johnny Joint rod end to get maximum articulation out of your suspension! This is a single joint only, see RJ 301000 101 for a complete kit. Finish is zinc plating.