Weld Mount AT-5B Large Black Nylon Wire Tie Mount - Qty. 500 [805500B] Brand_C.E. Smith Get the best of both

Get the best of both worlds on your hand control motor with the new Tilt/Extend Tiller

The amount of torque required to rotate the swivel is set by adjusting the pressure on two nylon drag washers with a inch stainless steel lock nut at the bottom of the rod holder

8-Pin - Airmar B175HW

Rated for Underwater Use

Weld Mount AT-5B Large Black Nylon Wire Tie Mount - Qty. 500 [805500B] Brand_C.E. Smith Get the best of bothAT 5B Large Black Nylon Wire Tie Mount Qty. 500 The AT 5 tie mount is designed to be set into wet resin during the hull lay up or bonded with our acrylic adhesives. It's designed for a #5 wire tie and has an average pull strength of 150 lbs. It's approved for submerged bilge applications. Stop putting plywood in your hull just to have a place to drive wire tie screws. Saves material and labor costs!