Puch E50 Cases - USED plate It was welded onto the

It was welded onto the output shaft by whoever owned this engine before

- Maximum optimisation of engine performance and reduced fuel consumption

The cylinder is stamped Garelli

You have to bump start or have an external chain setup like Puch

Puch E50 Cases - USED plate It was welded onto thePuch E50 engine cases. These came of a Puch X 10. 4 bearing cases like most common USA Puchs would have had. This is just the cases. No internals and no clutch cover or kickstand clamp. Dirt and grease are included. Mating surfaces are good. Threads are good. However, the crankshaft failed in this engine and did score the crankcase as you can see in the last photo. Wild. Smooth that out and it should be good to go. This is a used part. No returns,