3/8 Inch Drive x 10 mm 6-Point Flare Nut Crowfoot Wrench Quantity:1 Diameter/Pitch: #10-32

Diameter/Pitch: #10-32

and tearing • Ball Peen Hammer – The flat and ball peen sides of the hammer head are made from 4140 Cr-Mo steel heat-treated to 52 HRC • Nonslip Grip – The textured handle surface provides a comfortable grip for hammering • Short Handle – Gain access into tighter spaces with the reduced handle length • Made in USA

tapered straight section clamps flat stock

Shoulder Length: 1-1/2"

3/8 Inch Drive x 10 mm 6-Point Flare Nut Crowfoot Wrench Quantity:1 Diameter/Pitch: #10-32Optimized for Engagement, Access, and Strength Our deep, 6 point design maximizes your contact with fittings and prevents slipping Reinforced Jaw Strength We reinforced our wrenches with material where it matters most to avoid high stress concentrations and prevent the jaws from spreading 15 Degree Offset Increases Access Angles The jaw opening is offset 15 degrees from the center of the wrench so that it can be flipped over to gain additional access