SM74 Cutting and creasing jacket Duct Blades This is the lever which

This is the lever which pushes the rear plate clamp forward to fully grip the rear edge of the plate

Regrettably these sometimes need replacing because they get left in rag sacks

but only the motor and capacitor is supplied

this is refunded in full if the old rollers are returned to us

SM74 Cutting and creasing jacket Duct Blades This is the lever whichThe D plate is another part of the extensive PerfPrintPlus system for advanced in line die cutting and creasing operation on press. Consistent quality without any embossing of the sheet can be achieved by mounting this special hard jacket on the blanket cylinder. The precision backing set is also recommended. When Standard or Precision LithoPerf is mounted on the impression cylinder the sheets stay flat and high stacks can be run.